How To Use Terps USA Products

How to Use Terpene Spray

Enhance the aroma and freshness of your flower in under 5 minutes. Watch the videos, then follow the steps below.

Terpene Spraying Guide Precision Directions using the Spray Master

How to Use Terpene Spray Quick Guide

1. 1
   Spread your flower on a flat trayLay your product out in a single, even layer so every piece gets coated.
2. 2
   Spray the top sideHold the Terps USA spray bottle 6-8 inches above the tray and apply an even mist across the surface.
3. 3
   Flip and spray the other sidePlace a second tray face-down on top, flip both trays together, and remove the top tray. Spray the newly exposed side.

   Tip: The two-tray flip keeps everything in place without touching the flower.
4. 4
   Seal and check after an initial restTransfer the treated flower into an airtight container or sealable pouch. Allow an initial 15–20 minute rest before checking the aroma. For a consistent comparison, evaluate again after approximately 24 hours; up to 48 hours is an optional longer evaluation.

   Tip: A resealable bag or airtight jar both work perfectly.
5. 5
   Compare your resultsCheck the aroma after the initial rest and again after a consistent longer interval if you want to compare batches. Keep notes on the spray amount and timing.

Make your signature terpene spray with the Terpene Alchemist recipe Index

How to Make Vape Carts with Liquidizer

Turn your concentrate into smooth, fillable vape liquid in minutes. Watch the video, then follow the steps below.

Terps USA Liquidizers contain no vegetable glycerin (VG). We do not recommend VG for making concentrate cartridges.

1. 1
   Gather your suppliesYou will need: 1 gram of concentrate, 2 mL of Terps USA Liquidizer, a syringe, a stirring tool, a small heat-safe dish, and an empty vape cartridge or stash bottle.
2. 2
   Measure Liquidizer for your concentrateStandard formula: 1 gram concentrate + 2 mL Liquidizer. *If you are using a liquid concentrate, use 1 mL concentrate to 1 mL Liquidizer. Flavor Burst additions remain the same as listed in the recipe.

   Tip: Measure concentrate by weight and Liquidizer by volume. Use the measured finished volume to calculate cartridge yield.
3. 3
   Combine with your concentratePlace 1 gram of concentrate in the small dish. Add 2 mL Liquidizer to 1 gram concentrate. *If you are using a liquid concentrate, use 1 mL concentrate to 1 mL Liquidizer. Flavor Burst additions remain the same as listed in the recipe.
4. 4
   Microwave for 10 secondsPlace the dish in the microwave and heat for 10 seconds. This softens the concentrate and makes mixing easier.

   Tip: Do not overheat. 10 seconds is enough - you can always add a few more seconds if needed.
5. 5
   Stir until smoothUse the stirring tool to mix the concentrate and Liquidizer together until the liquid is fully smooth with no remaining particles.
6. 6
   Fill your cartridgeUse the syringe or a squeeze stash bottle to draw up the finished liquid and fill your vape cartridge. Your cart is ready to use.

   Tip: Terps USA Liquidizer is available in multiple flavors - choose the one that matches your concentrate profile.